Recent content by patters

I like the vario - I'd seen your site before while researching the pin-outs years ago. As I mentioned earlier I had success when I used this schematic http://snowcat.de/gbmicro.html. Most of the others I referred to seemed to be wrong. If it doesn't work then maybe switch Serial In and Serial...

Most multimeters will have a continuity checker - it's pretty much impossible without that. You strip all the wires at one end of your cable, then touch one probe against an exposed wire, then touch the other probe against each pin in turn and when you hear the beep - that's the one that...

Years ago I posted in this thread about converting an F2A USB linker to use the GB Micro and, though I got it working in the end, I think it was blind luck and I'm pretty certain my pin-out diagram was wrong. It's generally so confusing because people have slightly different ideas about what is...

Since nobody seems to have listed the actual pin outs on the gameboy units - here is my diagram. I've successfully put a micro-style link plug on an F2A USB linker and can confirm it works fine: EDIT - Ah, seen Troz's post above. oops. I think it matches up so that's good. EDIT2 - Hmm, it...

Thanks. I thought you might have a multimeter, if so you'd be able to check the continuity of the pins from one side of the official converter to the other. I do have one, so I can use it to measure for the 3.3V line. Once I have that then I should be able to work out the rest. Now I need a link...

Hi Troz1820, Would it be possible for you to make available the pinouts of the GBA/SP link port Vs the Micro ones? It would be a huge help if you could. Here are the pinouts for the GBA/SP: http://www.ziegler.desaign.de/GBA/gba.htm#Description%20of%20the%20GBA%20link-port 1=3.3V (5V in...