I need help putting a ring around THIS picture. I'm making a control panel and it looks a little sparse so I want to put some rings around the controls like this:
The file to play with is HERE (that I think will print at the proper size).
1. There should be semicircles on either side.
2. The hole to the far left is for the joystick and the radius of the semicircle should be at the center of that hole.
3. I'd also like guidelines so I can line it up properly so please include centerlines vertically and horizontally and a centerline vertically which passes through the joystick hole center.
4. Try to make it as proportional as possible.
I will print this out, tape it to some vinyl and use the outline as a guide to cut out the vinyl with some scissors/utility knife.
I'm trying to recreate this look:
Thanks!
The file to play with is HERE (that I think will print at the proper size).
1. There should be semicircles on either side.
2. The hole to the far left is for the joystick and the radius of the semicircle should be at the center of that hole.
3. I'd also like guidelines so I can line it up properly so please include centerlines vertically and horizontally and a centerline vertically which passes through the joystick hole center.
4. Try to make it as proportional as possible.
I will print this out, tape it to some vinyl and use the outline as a guide to cut out the vinyl with some scissors/utility knife.
I'm trying to recreate this look:
Thanks!